The latest Crop Progress and Condition report from Kansas Agricultural Statistics, on October 15, stated that grain sorghum maturity was 79%, ahead of last year and near the average. Harvest is also ahead of last year, 19% for this year but behind from the last 5-year average (28%). Nonetheless, wet conditions and mild temperatures will delay harvest in several regions across the state.
The weather conditions experienced from early-September to early-October are critical for sorghum as related to the grain filling rate and determining final grain weight. Temperatures and precipitation have split across the state, with warmer-than-normal conditions in the northwest and southeast. Cooler conditions prevailed in the north central and central parts of the state. There was a small area of east central Kansas that had excessive moisture but much of the state had less than half of the normal precipitation for the period (Figure 1).
Figure 1. a) Departure from normal temperatures; b) Departure from normal precipitation.
In recent years, a common question from producers is related to the dry down rate for sorghum when approaching the end of the season. Based on previous information, the average dry down rate depends on the weather, primarily temperature and moisture conditions – but data from modern hybrids is not available. The weather outlook for November calls for an increased chance of above-normal temperatures with chances for normal precipitation. Normal precipitation in November is much less than in October. This would favor a faster dry down rate than average but any sorghum impacted by freeze will present challenges in the final dry down rate.
From a crop perspective, the overall cumulative GDD from flowering to maturity is about 800-1200 (based on 50 degrees F as the base temperature), with the shortest requirement in GDD for short-season hybrids. Before maturity, from beginning of grain filling (soft dough until maturity), grain moisture content within a grain will go from 80-90% to 25-35% where black layer is usually formed (Figure 2). From maturity (seen as a “black-layer” near the seed base; Figure 2) to harvest time, sorghum grain will dry down from about 35 to 20 percent moisture, but the final maximum dry mass accumulation and final nutrient content will have already been attained at maturity.
Figure 2. Sorghum growth stages from half-bloom and grain filling (including soft dough, hard dough, and physiological maturity). Infographic representing changes in grain coloration and moisture content during grain filling period until black layer formation, maturity. K-State Research and Extension.
Grain water loss occurs at different rates but with two distinct phases: 1) before “black layer” or maturity (Figure 2), and 2) after black layer. For the first phase, the Figure 2 presents the changes in grain moisture from soft dough until physiological maturity of sorghum.
To answer the rate of dry down question from many of our producers, a study was conducted to investigate the effect of the grain dry down rate from the moment of “black layer” until commercial harvest grain moisture is reached. For the conditions experienced in 2018 (from early September until early October), the overall dry down rate was around 0.7% per day (from 33% to 14% grain moisture) – taking an overall period of 28 days (from September 5 to October 8).
Figure 3. Grain moisture dry down across different sorghum hybrids for a study located near Manhattan, KS. Horizontal dashed lines marked the 33% grain moisture at black layer formation and 14% grain moisture around harvest time*. The infographic in the right panel reflects the different stages of the grain for sorghum from right to left – before to black layer formation. K-State Research and Extension.
This dry down process can be delayed by:
It is expected that the dry down rate will decrease to <0.5% per day for late-planted sorghum entering reproductive stages later in the growing season (similar as reported in corn). A similar decrease is also expected for sorghum that was exposed to late-season stress conditions (e.g., drought, heat, and freeze). Under these conditions, maturity may be reached with high grain water content and the last stages after black layer formation could face lower temperatures and higher humidity. These main factors should be considered when the time comes to schedule harvest.
You can track temperature and humidity levels on the Kansas Mesonet web site at http://mesonet.k-state.edu/weather/historical/ by selecting the station and time period of interest.
Ignacio A. Ciampitti, Crop Production and Cropping Systems Specialist
Mario Secchi, KSUCROPS Production, Dr. Ciampitti’s Lab
Luiz Moro Rosso, KSUCROPS Production, Dr. Ciampitti’s Lab
Mary Knapp, Weather Data Library